Belt: Rough-Top incline conveyor system belt.
Bed: 12 gauge powder painted formed steel slider bed. Bed sections are 6.5" deep x 6', 8' or 10' long bolted together with splice plates.
Under-Trussed Bed: Bed sections 24' or longer equipped with under-trussed reinforcement to prevent sag.
Double Nose Over: Two 16" long adjustable bed sections provide a two step transition from incline to horizontal.
Tail Pulley: 4" diameter crowned with 1-3/16" shaft for belt widths to 30", 6" diameter crowned with 1-7/16" shaft turned down at ends for 36" wide belt.
Drive Pully: 8" diameter drive pulley crowned and lagged with 1-7/16" diameter shaft.
Snub Rollers: 2-1/2" diameter at drive pulley, 2" diameter at tail pulley.
|
Return Idlers: 1.9" diameter, adjustable.
Pop-Out Roller: Free floating, 1-3/8" diameter rollers located at tail pulleys with gravity connector rods. Will lift out if anything is caught between roller and tail pulley.
Floor Supports: Adjustable supports from 31" to 45", measured from floor to top of belt, knee braces included.
Take-Up: Located in center drive assembly, provides 24" of belt take-up.
Bearings: Sealed and prelubricated with cast iron housing.
Motor: 3/4 HP 230-460-3-60 totally enclosed.
Belt Speed: 60 feet per minute, constant speed.
Finish: Green Powder Coat Finish.
|